Table of Contents
Advertisement
TABLE 7-4
Home CHM
Cycle Pick/Place
Cycle Gripper
Cycle S Axis
Cycle L Axis
Cycle Solenoid
Cycle Drum
7.4.3.1
Self Test
The following actions occur during the Self Test diagnostic:
The gripper fingers of the CHM move to the home position.
The CHM cycles the long and short axes once, then moves to the home position at
the bottom of the long axis.
The spindle assembly is returned to home position.
1. Select the Maintenance Menu by pressing
2. Select the Diagnostics Menu by pressing
3. Select Self Test by pressing
To abort the Self Test diagnostic, press Escape and Enter.
7.4.3.2
Position to Element Test
This diagnostic positions the CHM in front of a tape drive, cleaning cartridge slot, or
a particular slot in the cartridge holder.
7-16
Sun StorEdge L400 Installation and User's Guide • April 1998
Diagnostic Menu Descriptions (Continued)
Moves the CHM to the park position, then to the opposite
end of the long axis.
Causes the CHM to take a cartridge from a specified slot
or CTS and replace it in the same slot. You must specify
the source slot (see
place cycles that the CHM should perform in increments
of 10 (up to 250).
Causes the gripper to open and close. You must specify
the number of cycles in increments of 10 (up to 250).
Causes the CHM to move end to end along the short axis
(the axis where the CHM moves in and out). You must
specify the number of cycles the CHM must perform in
increments of 10 (up to 250).
Causes the CHM to move end to end along the long axis.
You must specify the number of cycles the CHM must
perform in increments of 10 (up to 250).
Cycles the door solenoid, used to lock the front door. You
must specify the number of cycles the CHM must
perform in increments of 10 (up to 250).
Rotates the drum assembly 180 degrees.
↓
TABLE 7-3
) and the number of pick/
↓
↑
or
,then Enter.
↓
↑
or
, then Enter.
↑
or
, then Enter.
Advertisement
Table of Contents
