Table of Contents
Advertisement
D.2
SCSI Sense Key Errors
The SCSI sense key error messages, listed in
window on the computer system. Further descriptions of each SCSI Sense Key Error
are presented on the following pages.
TABLE D-2
SCSI Sense Error
Description
Messages
0h - No sense
There is no specific sense key
information to report.
2h - Not Ready
The tape library cannot accept any
tape motion commands.
4h - Hardware
The tape library detected a
Error
nonrecoverable hardware failure
during a selftest or while performing
a command.
5h - Illegal Request
The unit detected an illegal
operation request. For example, an
illegal parameter was sent with a
command or the tape library was in
the wrong mode to execute the
command.
6h - Unit Attention
Something happened that may have
changed the state of the unit. For
example, the unit was powered on, a
tape was loaded into the tape drive,
or the SCSI bus was reset.
Bh - Aborted
The tape library aborted a command
Command
(typically operator aborted).
D-8
Sun StorEdge L400 Installation and User's Guide • April 1998
SCSI Sense Key Error Messages
, appear in the console
TABLE D-2
Action
N/A
Perform one or more of the following actions:
- Insert a data cartridge in the tape drive.
- Close the door.
- Put the tape library under SCSI control. To do
so, select SCSI Interface under the Control Mode
Menu.
Try the command again. If the error message
persists, replace the tape drive.
Retry the operation.
N/A
Retry the operation.
Advertisement
Table of Contents
