Powering On The Tape Library - Sun Microsystems StorEdge L400 Installation And User Manual

If this is not the last device in the SCSI chain, then:
a. Connect one end of another SCSI cable to the other single SCSI port on the
back panel of the tape library.
b. Connect the other end of the SCSI cable to the SCSI port on the back panel of
the next peripheral unit in the stack.
Repeat this step until you reach the last SCSI device.
c. Ensure that the last device on the SCSI bus is properly terminated.
3.6

Powering On the Tape Library

This section describes how to power on the tape library. The power switch and
connector for the power cord are located on the back panel of the tape library
(
FIGURE 3-1
Note – Power cords are supplied with the tape library for 120-volt use in the United
States and Canada.
With the power switch in the off (0) position and the door closed and locked:
1. Connect the three-hole end of the power cord to the power receptacle on the rear
panel of the tape library, then connect the three-prong end of the power cord to
the nearest power source outlet.
Caution – Sun products have been designed to work with single-phase power
systems having a grounded neutral conductor. To reduce the risk of electric shock,
do not plug Sun products into any other type of power system. Contact your
facilities manager or a qualified electrician if you are not sure what type of power is
supplied to your building.
Note – The tape library has self-ranging voltage selection, so you do not need to
change the voltage setting.
3-6 Sun StorEdge L400 Installation and User's Guide • April 1998
).