7.2
Interface Menu
The Interface Menu allows you to put the tape library into various modes from
which you can control the tape library.
The Interface Menu consists of the following submenus:
Control mode
Configure 25-Pin Port (not supported)
Configure 9-Pin Port (not supported)
Configure 4-Pin Port (not supported)
7.2.1
Control Mode
The Control Mode Menu determines what controls the motions of the CHM. The
tape library must be in one of the three sequential modes in order to use the
SunDiag
modes:
LCD Interface
SCSI Interface
Sequential 1
Sequential 2
Dual Sequential
25-Pin Serial Port (not supported)
9-Pin Serial Port (not supported)
↑
Use
7.2.1.1
LCD Interface
LCD Interface Mode is required when you want to control the motions of the CHM
though the display panel. For example, diagnostics can be performed that test
individual motions, such as picking and placing cartridges from specific locations.
Note – You must be in LCD interface mode to run certain tests in the Maintenance
Menu.
1. Disable security.
2. Select the Interface Menu by pressing
™
™
or SunVTS
system exerciser. The tape library has the following control
to scroll up through the control mode functions and
↓
to scroll down.
↓
↑
or
, then Enter.
Chapter 7
Tape Library Menu Functions
7-3