Adjusting The Steering Head Bearing Play - Husqvarna FE 450 EU 2020 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.12
62
400738-11

Adjusting the steering head bearing play

S03554-10
Main work
–
Move the handlebar to the straight-ahead position. Move the
fork legs to and fro in the direction of travel.
Play should not be detectable on the steering head bear-
ing.
» If there is detectable play:
–
Adjust the steering head bearing play.
–
Move the handlebar to and fro over the entire steering range.
It must be possible to move the handlebar easily over the
entire steering range. There should be no detectable detent
positions.
» If detent positions are detected:
–
Adjust the steering head bearing play.
–
Check the steering head bearing and replace if neces-
sary.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
1
Loosen screws .
–
2
Remove screw .
–
Loosen and retighten screw
Guideline
Screw, top steering
head
–
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
–
1
Tighten screws .
Guideline
Screw, top triple
clamp
–
Mount and tighten screw
Guideline
Screw, top M8
steering stem
Finishing work
–
Check steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
( p. 62)
( p. 62)
p. 55)
p. 55)
3
.
M20x1.5 12 Nm (8.9 lbf ft)
M8 17 Nm (12.5 lbf ft)
2
.
17 Nm (12.5 lbf ft)
Loctite
p. 61)
p. 55)
®
243™