11.12
Adjusting the steering head bearing play
SERVICE WORK ON THE CHASSIS 11
Main work
–
Move the handlebar to the straight-ahead position. Move the
fork legs to and fro in the direction of travel.
Play should not be detectable on the steering head bear-
ing.
»
If there is detectable play:
–
Adjust the steering head bearing play.
–
Move the handlebar to and fro over the entire steering range.
H01167-01
It must be possible to move the handlebar easily over the
entire steering range. There should be no detectable detent
positions.
»
If detent positions are detected:
–
Adjust the steering head bearing play.
–
Check the steering head bearing and replace if
required.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Remove fuel tank breather
–
Loosen screws
–
Loosen screw
–
Loosen and retighten nut
Guideline
Nut, steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp
F02249-10
to avoid stresses.
–
Tighten screw
Guideline
Screw, steering stem M8
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Position fuel tank breather
Finishing work
–
Check the steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
p. 40)
1
.
2
.
3
.
4
.
M20x1.5
10 Nm (7.4 lbf ft)
3
.
20 Nm (14.8 lbf ft)
2
.
M8
20 Nm (14.8 lbf ft)
1
.
p. 46)
(
p. 47)
(
p. 47)
p. 40)
p. 40)
47