Advertisement
Rockshaft Installation
1. Take the bearing castings and insert the straight and
angled grease fittings to create a set of four bearings.
Coat the curved portion of each bearing with a thick
coat of grease. Install the rockshaft by fitting the
bearing sets around the rockshaft, with the straight
grease fittings on top, attach them to the underside of
the angle pads welded to the Frame Tubes, with
3/4-10 x 9 Bolts, Lock Washers and Nuts.
Bolt,3/4-10 x 9
Grease Fitting
Bearing
Lock Washer,3/4
Nut,3/4-10
Grease Fitting,
65 Deg
Flat
Washer,3/4
Hair Pin Cotter
Clevis Pin,
5/8 x 2-1/2
Flat Washer,5/8
2-6
TABLE OF CONTENTS
4 x 16
Hyd Cyl
Cotter Pin,
Grease
1/8 x 1-1/4
Fitting
Grease Fitting,
Transport
Lock
Clevis Pin,
3/4 x 2-3/4
Figure 2-4: Rockshaft Installation
2. Attach the Transport Locks to the Rockshaft Lug
using 3/4 x 2-3/4 Clevis Pin, Flat Washers and 1/8 x
1-1/4 Cotter Pin. Place the other end between the
Rear Frame Tube Lugs using 5/8 x 2-1/2 Clevis Pin,
Flat Washers and Hair Pin Cotter. The hole is the
storage position and the slot is the locked position.
3. Install the two 4 x 16 Hydraulic Cylinders by attaching
the cylinder base to the cross member lug and secure
with hardware provided.
4 x 16
Hyd Cyl
Rockshaft
Bearing
Lock Washer,3/4
Nut,3/4-10
65 Deg
Bolt,3/4-10 x 9
Tire and
Wheel Asm
Wheel Bolt
WL360 Rockshaft
9J577-0822
Advertisement
