Advertisement
Tire Installation
WARNING
Use a torque wrench to assure proper torque.
Insufficient torque can cause stud breakage and
damage the wheel pilots. Over torque can
overstress the studs and strip the threads.
NOTE
All Tire/Wheel Assemblies are mounted with the Valve
Stem facing outward from Hub and Spindle.
1. Remove the eight 9/16-18 Wheel Bolts from the Hub.
Install the tire and wheel assembly onto the hub. The
W360 Pulvi-Mulcher uses 12.5L x 16 - 14 ply tires and
should be inflated to 50 PSI.
2. Re-Install the Wheel Bolts and tighten to 50
foot-pounds using the sequence in Figure 2-5. Then
tighten to full torque of 90-100 ft-lbs. It is good
maintenance practice to lubricate the wheel bolts prior
to inserting.
9J577-0822
TABLE OF CONTENTS
3
Figure 2-5: Stud Tightening Sequence
NOTE
Torque will drop after the first 10 hours of operation.
Check the nuts for proper torque after this interval and
re-tighten them.
Hub
Figure 2-6: Tire Installation
1
8
5
2
Tire
6
4
7
Wheel Bolt
2-7
Advertisement
