Advertisement
Wing Frame C-Tooth
Installation
1. Tooth locations are shown in Figure 2-20. Install 7
Teeth on the front tube and 8 on the rear as shown in
Figure 2-16.
2. Attach the Control Arms to the Front Tubes using
5/8-11 U-Bolts, Lock Washers and Nuts. Repeat for
the Rear Tubes. See Figure 2-24.
3. Attach the Cylinder Arm to the Front Tube using
5/8-11 U-Bolts, Lock Washers and Nuts.
4. Connect the Front and Rear Tubes by placing two
Straps onto each side of the Front and Rear Control
Arms. Slide a 3/4 Flat Washer on each side of the
Control Arm Lug, place one 3/4 Flat Washer onto the
3/4 x 2-3/4 Clevis Pin then slide through, place a 3/4
Flat Washer on Pin and insert 1/8 x 1-1/4 Cotter Pin.
5. Check to ensure there is no binding and no
interference with the Tines.
6. Attach the 3 x 8 Hydraulic Cylinder to the Front Tube
using Pins provided.
Spring Tooth
Tooth Clamp
Clamp Strap
Lock Washer,1/2
Figure 2-24: C-Tooth Installation
2-24
TABLE OF CONTENTS
Nut,1/2-13
9J577-0822
Advertisement
