Advertisement
Storage
1. The service life of the Pulvi-Mulcher will be extended
by proper off-season storage practices. Prior to
storing the unit, complete the following procedures:
a. Completely clean the unit.
b. Inspect the machine for worn or defective parts.
Replace as needed.
c. Repaint all areas where the original paint is worn
off.
d. Apply a light coating of oil or grease to exposed
cylinder rods to prevent them from rusting.
e. Grease Transport Axle Bearings and Wheel
bearings. See Figure 4-3.
2. Store the unit in a shed or under a tarpaulin to protect
it from the weather. The ground tools and tires should
rest on boards, or some other object, to keep them out
of the soil.
3. When the unit is stored in the raised position, make
sure the Transport Locks are installed to prevent
settling.
4. Relieve Hydraulic Pressure in hoses after Transport
Locks are installed.
5. Block wheels before unhitching from tractor.
Maintenance Chart
(Subject to change without notice)
Fasteners, Wheel Hub Bolts
Adjust Scraper if equipped
Grease Wheel Hub
Repack Wheel Hub Bearings
Tighten RollerAxle
Wheels and Clamps
** Clean machine
Grease after cleaning
Touch-up paint
** Avoid spraying high pressure washer directly at bearing seals and electrical connections.
4-6
TABLE OF CONTENTS
Initial Run-In
20 Hours
X
Table 4-1: Maintenance Chart
50 Hours
100 Hours/Annually
X
X
X
X
X
X
X
Storage
X
X
X
9J577-0822
Advertisement
