Advertisement
Wing Roller Installation
Position the Bearing between two bearing flanges and
assemble it to the inside of the Wing Frame Bearing
Plate using 1/2-13 x 1-1/2 Carriage Bolts, Lock Washers
and Nuts. Insert the front and rear roller assembly ends,
without the Clamp Ring into End Plate Bearings.
NOTE
Be sure clamp rings are towards the outside, so assembly
can be adjusted when needed.
Lock Washer,1/2
Nut,1/2-13
9J577-0822
TABLE OF CONTENTS
Install End Bracket with the bearing to the outside on the
Front and Rear Frame using 3/4-10 U-bolts, Lock
Washers and Nuts.
NOTE
Crowfoot wheels have arrows on the spokes showing
direction of rotation. Arrows must follow direction of travel.
Bearing
Bearing Flange
Figure 2-35: Wing Roller Installation
U-Bolt,3/4-10
Lock Washer,3/4
Nut,3/4-10
End Bracket
Carriage Bolt,
1/2-13 x 1-1/2
Assembly
2-37
Advertisement
