Advertisement
Attaching to the Tractor
1. Align the tractor drawbar with the machine. Raise or
lower the Hitch, as needed, using the Jack. Attach the
unit with proper size hitch pin. See Table 3-1.
2. Always rotate Jack to its storage position before
setting the machine in motion.
3. Clean all hydraulic couplings and attach to the tractor.
4. Fully extend the hydraulic lift wheel cylinders, and
place the cylinder lockouts in the Transport Lock
Position over the cylinder rods. Secure the lockouts
with the lockout pins.
5. Attach Safety Chain to tractor allowing plenty of
movement for turning both directions. The safety
chain should latch securely to prevent it coming loose.
See Figure 3-1.
6. Plug in the 7-Pin connector for the lights.
•
Make sure the tractor has a good clean
receptacle, free of dirt and corrosion.
HHCS,1-8 x 3-1/2
Tractor Drawbar
9" MAX
Safety Chain
3-2
TABLE OF CONTENTS
Drawbar
HHCS,1-8 x 3-1/2
Tractor Drawbar
Figure 3-1: Safety Chain To Tractor
•
Make sure the 7-Pin connector is inserted ALL the
way in. With tighter fitting pins, operator may think
the connector is all the way in, but really isn't.
•
Make sure the tractor receptacle cover latches
over the keyway on the 7-Pin connector to hold
the connector in place.
•
If an operator plugs in the 7-Pin connector, but
the lights do not seem to work right, check the
above items to make sure there is a good
connection with the 7-Pin connector.
DRAWBAR CAT
2
3
4
Table 3-1: Hitch Pin Size
Flat Washer,1" SAE
Locknut,1-8
Drawbar
Safety Chain
Min Pin Size
Max PTO HP
1-14" (30mm)
154 (115 Kw)
1-1/2" (38mm)
297 (185 Kw)
2" (50mm)
402 (300 Kw)
Flat Washer,1" SAE
Locknut,1-8
9J577-0822
Advertisement
