Advertisement
V-Leveler Installation -
Optional
Refer to Figure 2-45 for V-Leveler mounting dimensions.
1. Place the V-Leveler Bracket on top of the center
drawbar tube. Secure with 3/4-10 U-Bolts and
Locknuts. Do not tighten at this time. Attach the
V-Leveler to the Bracket by sliding 1 x 12-1/2 Pin
through and securing with 1" Flat Washers, Hair Pin
Cotter and 5/32 x 1-1/2 Cotter Pin.
2. Attach the Arm Weldments to the Front Frame Tube
using 5/8-11 U-Bolts and Locknuts. Slide the
V-Leveler Bar up to the Arm Weldment and insert
Clevis Pin at the highest position that does the
required job. Place Flat Washer on Clevis Pin and
secure with Hairpin.
3. Adjust V-Leveler Bracket and Arm Weldments,
Tighten U-Bolts. See Figure 2-47.
Bracket RH
Bracket RH
3J551
Angle RH
Leveler Angle
3J556
3J559
Bracket RH
Frame Tube
RH Outer
Frame Tube
Bracket
3K678
2-48
TABLE OF CONTENTS
RH Wing
3J551
Angle RH
3J556
3J551
LH Outer
4-1/4"
Center Frame
59-3/16"
Bracket
3K683
Figure 2-45: V-Leveler Mounting Dimensions - Optional
Wing V-Leveler Installation
1. Attach the Left and Right Hand Brackets to the Front
Wing Frame Tube using 1/2-13 U-Bolts, Lock
Washers and Nuts. When the bracket is in position,
left and right hand is determined by which side of the
bracket the arm projects from. See Figure 2-45.
2. Attach the Left and Right Hand Adjustment Angles to
the Brackets with 1/2-13 x 1-1/2 Bolts, Lock Washers
and Nuts. The hoses mounted on the front of the wing
tube may need to be moved and tied down with a
cable tie to allow proper mounting of brackets. Do not
tighten at this time.
3. Attach the Wing Levelers onto the Adjustment Angles
to the highest position that does the required job.
Secure with 1/2-13 x 1-1/2 Bolts, Lock Washers and
Nuts. Tighten all fasteners.
NOTE
If the soil pushes ahead of the bar it is set too low.
RH Outer
Frame Tube
Angle RH
3J556
4-1/4"
LH Wing
Angle LH
Angle LH
3J557
3J557
59-3/16"
Bracket LH
3J552
Bracket LH
3J552
Bracket LH
3J552
Angle LH
Leveler Angle
3J557
3J559
LH Outer
Frame Tube
Bracket
3K678
V-Leveler
Weldment
177568
9J577-0822
Advertisement
