Advertisement
Rear Hitch Installation -
Optional
1. Place the 4 Hole Plate on top on the rear center frame
tube, plate should be flush with the end of the tube.
See Figure 2-47.
2. Position the Hitch Weldment under the rear center
frame tube with hitch ear pointing out. Secure the two
components using four 3/4-10 x 9 Bolts, Lock
Washer, Nuts.
U-Bolt,3/4-10
WL360 Hitch
2-50
TABLE OF CONTENTS
Plate
Hitch Weldment
Figure 2-47: Rear Hitch - Optional
3. Position the Tube Assemblies between the Left and
Right Center Rear Frame Tubes.
4. Attach to the Left and Right Frame Tubes using
3/4-10 U-Bolts, Lock Washer and Nuts.
5. Align the two Tube Assemblies on each side of the
Center Frame Tube connect using 3/4-10 x 6-1/2
Bolts, Lock Washers and Nuts.
6. Ensure Tubes are aligned, tighten hardware.
7. Rear Hitch Maximum recommended tongue weight is
approximately 1,000 pounds.
Tube
Assembly
Bolt,3/4-10 x 6-1/2
Nut,3/4-10
Tube
Assembly
9J577-0822
Advertisement
