Table of Contents
Advertisement
2211-13 & -15 Fold Lock
Assembly
1. Place fold lock assembly on the front side of the 7 x 4
rear frame tube and mount plate on the back side of
the rear frame tube (See Figure 3-3.)
IMPORTANT
The placement dimensions are an approximation and
may need to be adjusted for proper alignment of
wing fold safety pin.
2. Install 3/4-10 x 13 hex head cap screws and lock
nuts to hold the fold lock and mount plate in place.
Do not tighten screws (See Figure 3-4.)
IMPORTANT
Fold wing until proper fit is achieved prior to
tightening screws.
3. Fold wings over. Adjust fold lock assembly location if
necessary. Tighten screws after proper fit is
achieved.
NOTE
It may be necessary to unscrew cylinder clevis one or
two revolutions to prevent it from overloading fold lock
when cylinder is fully retracted.
ASSEMBLY INSTRUCTIONS
3-7
Advertisement
Table of Contents
