Advertisement
Tires
Pulvi-Mulcher machines are supplied with 320/70R15
Tires and should be inflated to 70 PSI.
When Re-Installing the Wheel Bolts tighten to 50
foot-pounds using the sequence in Figure 4-4. Then
tighten to full torque of 90-100 ft-lbs. It is good
maintenance practice to lubricate the wheel bolts prior to
inserting.
8
3
5
Figure 4-4: Stud Tightening Sequence
9J577-0822
TABLE OF CONTENTS
1
6
4
7
2
8 BOLT
Warning Lamps
When plugging in the 7-Pin Warning Lamp Connector:
1. Make sure the Tractor has a good clean Receptacle,
free of dirt and corrosion. See Figure 4-5.
2. Make sure the 7-Pin Connector is inserted ALL the
way in. With tighter fitting pins, operator may think the
Connector is all the way in, but really isn't.
3. Make the sure the Tractor Receptacle Cover latches
over the keyway of the 7-Pin Connector to hold the
Connector in place.
If an operator plugs in the 7-Pin Connector, but the lights
Do Not seem to work right, check the above items to make
sure there is a good condition with the 7-Pin Connector.
Amber
Lamp
Red Lamp
Warning
Lamp Harness
7-Pin/4-Pin
Harness
Figure 4-5: Warning Lamps
Amber
Lamp
Flasher Control
Module
4-5
Advertisement
