Advertisement
Center Frame C-Tooth
Installation
1. Tooth locations are shown in Figure 2-12. Put 15
Teeth on the front tube and 14 on the rear as shown
in Figure 2-16.
2. Attach the Control Arms to the Front Tubes using
5/8-11 U-Bolts, Lock Washers and Nuts. Repeat for
the Rear Tubes. See Figure 2-17.
3. Attach the Cylinder Arms to the Front Tube using
5/8-11 U-Bolts, Lock Washers and Nuts.
4. Connect the Front and Rear Tubes by placing the Link
Assembly onto the Control Arms. On the Front Tube
place a 3/4 Flat Washer on each side of the Control
Arm Lug, slide 3/4 x 2-3/4 Clevis Pin through, place
four 3/4 Flat Washers on the Pin and insert 1/8 x 1-1/4
Cotter Pin.
5. On the Rear Tube place a 3/4 Flat Washer on each
side of the Control Arm Lug, place one 3/4 Flat
Washer onto the 3/4 x 2-3/4 Clevis Pin then slide
through, place three 3/4 Flat Washers on the Pin and
insert 1/8 x 1-1/4 Cotter Pin.
6. Check to ensure there is no binding and no
interference with the Tines.
7. Attach the 3 x 8 Hydraulic Cylinders to the Front
Tubes using Pins provided.
Spring Tooth
Tooth Clamp
Clamp Strap
Lock Washer,1/2
Figure 2-16: C-Tooth Installation
2-16
TABLE OF CONTENTS
Nut,1/2-13
9J577-0822
Advertisement
