Advertisement
LED Lamp and Harness
Installation
NOTE
Unless otherwise noted the following installation
instructions apply to all WL Models.
1. Install a Lamp Bracket approximately 46" from center
line on each side of the rear frame tube using 1/2-13
U-Bolts and Flanged Locknuts. See Figure 2-40.
2. With the Red LED Lamp facing rearward, attach the
Lamp to the outside and the Decal Bracket to the
inside of the Lamp Bracket using 1/4-20 x 1-1/2
Screws and Locknuts. See Figure 2-41.
3. Install a Lamp Bracket flush with the rear frame tube
end using 1/2-13 U-Bolts and Flanged Locknuts. See
Figure 2-40.
4. Place the Amber LED inside the Light Shield. Attach
Lamp and Shield to the outside and the Decal Bracket
to the inside of the Lamp Bracket with 1/4-20 x 1-3/4
Screws and Locknuts. See Figure 2-41.
5. Attach the Light Module to the Light Module Bracket
using two 1/4-20 X 1-1/2 Screws and Locknuts. See
Figure 2-39.
6. Attach the Light Module Bracket to the rear of the left
Inner Frame Tube just in front of the Rear Frame
Tube using 3/8-16 U-Bolts and Locknuts.
IMPORTANT
Connectors marked with Yellow Tape is Left Side and
Green Tape is Right Side.
7. Layout the LED Lamp Harness along the Rear Frame
Tube with the 3-Way and the 2-Way connector cords
marked with yellow tape on the left side and the
3-Way and the 2-Way connector cords marked with
green tape on the right side of the machine. Plug the
3-Way connectors into the Red Lamps and the 2-Way
connectors into Amber Lamps. Route the Harness up
the Left Inner Frame Tube to the Light Module 6-Way
connector and connect.
8. Connect the 7-Pin Harness 4-Way connector into the
Light Module. Run the Harness along the Left Inner
Frame Tube with the Hydraulic Hoses, down the
Drawbar Loops and through the Hose Holder to the
Hitch Point.
9. Bundle and secure any excess cord with tie straps.
10. Apply the reflector decals to Decal Plate Mounts. The
amber reflector decals should be front facing on the
outer Decal Plate Mounts. The red reflector decals
and orange decals should be rear facing on both the
inner and outer decal plate mounts. See Figure 2-41.
2-40
TABLE OF CONTENTS
IMPORTANT
All wires must be firmly attached to machine frame
members, or hydraulic lines, so they don't sag or
become torn loose by field debris. Use the cable and
hose ties provided.
Light Module Bracket
Figure 2-38: LED Module and Bracket
11. Attach the SMV Sign to the bracket weldment located
on the rear of the Center Frame Tube using two
5/16-18 x 1 Screws, Flat Washer and Nuts.
Light Module
LED Module&Brkt178506
Screw,1/4-20 x 1-1/2
Locknut,1/4-20
9J577-0822
Advertisement
