Transport Lock
Fold the wings for transport as described above. In transport relieve the hydraulic
pressure until the cylinder transport lock is tight against pin in the lift arm. There should
be no need to do anything with the pulverizer when going from field to transport or
transport to field.
Packer Wheel Adjustment
Allow just enough looseness so each wheel will turn by itself. If wheels become worn,
loosen the clamp at the end of each roller axle and tighten as needed.
Scraper Adjustment
Set scrapers to clear wheels by 1/8" to 3/16". In operation, wheels will move back slightly,
taking up the clearance between the axle pipe and wheel hub.
Scrapers for 20" wheels are reversible.
NOTE:
Always raise and lower the wings with the machine raised into transport
position to ease the side load on the roller bearings and the end roller clamps.
190rev501
Page 7
9J698