Advertisement
Wing Tooth Tube Bracket
Assembly
S-Tine Machines
Assemble two 9J091 S-Tine Brackets to the front vertical
tube supports top and middle holes using 1/2-13 X 5
Bolts and Locknuts. On the rear vertical tube supports
top and middle holes assemble two 9J091 S-Tine
Brackets and Spacers using 1/2-13 X 6-1/2 Bolts and
Locknuts. See Figure 2-8.
2-20
TABLE OF CONTENTS
C-Tooth Machines
Assemble four 9J090 C-Tooth Brackets to the front and
rear vertical middle and bottom holes tube supports using
1/2-13 X 5 Bolts and Locknuts. See Figure 2-9.
Figure 2-19 shows the proper positioning of these
brackets when assembled. The brackets must be
assembled exactly as shown in the illustration.
(Reversing some of these brackets will cause
interference later when mounting spring teeth.)
Figure 2-19: Wing Tube Bracket Locations
9J577-0822
Advertisement
