Advertisement
Wing Hinge and Fold
Cylinder Installation
WARNING
Do not attempt to lift heavy parts (such as the
frame, rockshaft, and pull hitch) manually. Use a
hoist or a fork lift to move these parts into
position.
1. Attach the base end of a 4 x 24 Hydraulic Cylinder to
the left and right side Center Frame Lugs with Pins
provided. The rod end must face outward and ports
must face the rear of the machine. See Figure 2-18.
2. Align the Top Hole of the Wing Frame Hinge Lug with
the Center Frame Hinge Lug. Secure with 1-1/4 x 10
Pin, 1-1/4 Flat Washer and 5/16 x 2 Roll Pin.
3. Take four 1-1/4 x 8-3/4 Pins, insert 5/16 x 2 Roll Pin
into one end, set aside.
4. Align the two Links with cutout downward and facing
outward on the inside of the Wing Frame Hinge Lug
Holes. Place Bushing with a 1-1/4 Flat Washer on
each end between the Links. Install two 1-1/4 Flat
Washers onto previously set aside 1-1/4 x 8-3/4 Pin.
Slide Pin through Wing Hinge Lug Holes, Links, Lock
Washers and Bushing. Place two 1-1/4 Flat Washers
on Pin. Secure with 5/16 x 2 Roll Pin.
5. Slide a 1-1/4 Flat Washer, Roller Assm and two 1-1/4
Flat Washers onto previously set aside 1-1/4 x 8-3/4
Pin. Align Cylinder Rod end with 1-1/4 Flat Washers
on each side with the two Links. Slide Pin through and
place a 1-1/4 Flat Washer, Roller Assm and two 1-1/4
Flat Washers on end of Pin. Secure with 5/16 x 2 Roll
Pin.
2-18
TABLE OF CONTENTS
9J577-0822
Advertisement
