Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual page 201

Figure 117: Example - PRAID EP5x0i in riser module 1
▶ Connect the corresponding SAS/SATA cables or Oculink cables to the
PRAID EP5x0i.
▶ Connect the HDD LED cable to connector "HDD LED" on the system board
(see circle).
▶ If applicable, connect the FBU cable to the FBU.
▶ Connect the SAS/SATA cables or Oculink cables the corresponding HDD
backplane.
For the cable plan, see
RX1330 M4
Expansion cards and backup units
"Appendix B" on page
Upgrade and Maintenance Manual
365.
201