Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual page 356

Appendix A
LAN speed indicator (2)
Status
yellow on
green on
off
Indication of LAN connection supporting Energy Efficient Ethernet (EEE
mode)
To configure the EEE mode, it is necessary that the onboard LAN or an add-in
LAN card supports this mode and the connected switch supports this mode as
well.
Indicator if
EEE mode is
active
LAN link/
transfer
indicator
LAN speed
indicator
Note on the onboard LAN controller
The system board is equipped with a Gigabit Ethernet Controller that
supports transfer rates of 10 Mbit/s, 100 Mbit/s and 1 Gbit/s.
The separate management LAN connector is used as a management
interface (iRMC S5) and is prepared for operation with the Remote
Management. Optionally LAN connector 1 can also be used for iRMC
S5 server management.
356
Description
Data traffic at a transfer rate of 1 Gbit/s.
Data traffic at a transfer rate of 100 Mbit/s.
Data traffic at a transfer rate of 10 Mbit/s.
Status
short flashing green 3x,
then off
short flashing yellow 1x,
then 2 seconds off
green off
short flashing green 1x,
then 2 seconds off
yellow off
Upgrade and Maintenance Manual
Description
A LAN connection has been
established (1 Gbit or 100 Mbit)
and EEE mode is active.
Data traffic at a transfer rate of
1 Gbit/s.
Data traffic at a transfer rate of
100 Mbit/s
RX1330 M4