Replacing The Power Distribution Board - Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

Power supply unit (PSU)
▶ Remove the power cord from the defective PSU, see
power cord" on page
Removing the defective hot-plug PSU
▶ Remove the PSU, see
Installing the new hot-plug PSU
▶ Install the PSU, see
Concluding steps
▶ Connect the power cord to the new PSU and secure it with a cable clamp,
see"Connecting the power cord" on page
▶ Only when replacing a PSU in a non-redundant configuration:
the server" on page
▶
"Performing a fan test" on page
6.4.5

Replacing the power distribution board

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶
"Suspending BitLocker functionality" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
114
46.
"Removing a hot-plug PSU" on page
"Installing a hot-plug PSU" on page
58.
96.
45.
Upgrade and Maintenance Manual
"Disconnecting the
105.
56.
Hardware: 15 minutes
43.
65.
46.
48.
108.
"Switching on
RX1330 M4