Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual page 206

Expansion cards and backup units
▶ If applicable, disconnect external cables to the expansion card.
▶
"Getting access to the component" on page
▶
"Locating the defective component" on page
▶ Remove the corresponding riser module, see
page 59.
Removing the defective expansion card
▶ Remove the expansion card, see
page 203.
▶ If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card, see
Installing the new expansion card
▶ If applicable, install the slot bracket, see
page 186.
▶ Install the expansion card, see
Connecting cables to the expansion card
▶ If applicable, connect internal cables to the expansion card.
For the cable plans, see
Concluding steps
▶ Install the corresponding riser module, see
page 61.
▶
"Reassembling" on page
▶ If applicable, connect external cables to the expansion card.
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶
"Enabling replaced components in the BIOS" on page
206
"Removing an expansion card" on
"Removing slot brackets" on page
"Installing an expansion card" on page
"Appendix B" on page
52.
56.
58.
Upgrade and Maintenance Manual
48.
44.
"Removing a riser module" on
"Installing a slot bracket" on
365.
"Installing a riser module" on
81.
187.
196.
RX1330 M4