Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual page 149

▶ Position the HDD backplane on the three hooks (see circles).
▶ Push the HDD backplane downward. Ensure that the HDD backplane fits
into the guides (A). There are five guides, three can be seen in figure.
CAUTION
▶
Ensure that none of the cables are strained or damaged!
Figure 68: Connecting the cables to the 3.5-inch HDD backplane
▶ Connect the following cables to the HDD backplane:
1 SAS/SATA cable, according to the length
2 SAS/SATA cable, according to the length
3 Power cable to backplane connector "X12"
4 SAS/SATA cable, according to the length
5 SAS/SATA cable, according to the length
6 SAS/SATA cable plug "P6" to backplane connector "SGIO"
7 OOB cable to backplane connector "SMBus"
For the cable plans, see
Concluding steps
▶ Insert all HDD modules, see
page 142.
Ensure that you reinstall the HDD module in the bay it was located
before the HDD backplane replacement.
▶
"Reassembling" on page
RX1330 M4
Hard disk drive (HDD) / solid state drive (SSD)
"Appendix B" on page
"Installing a 3.5-inch HDD module" on
52.
Upgrade and Maintenance Manual
365.
149