Installing The Server In The Rack - Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

4.5.2

Installing the server in the rack

CAUTION
At least two people are needed to position the server on the rack rails.
(For Japan, see "安全上のご注意".)
Additionally, a lifter is required in the following cases:
– The server weighs more than 50 kg.
– The server weighs more than 21 kg and is to be installed above the height of
25 U.
When using a lifter, this installation procedure needs to be carried out by
maintenance personnel.
RX1330 M4
For configurations below 32 kg:
At least two people are needed to lift the server into the
rack cabinet.
For configurations below 55 kg:
At least three people are needed to lift the server into
the rack cabinet.
For configurations above 55 kg:
At least four people are needed to lift the server into the
rack cabinet.
Upgrade and Maintenance Manual
Basic hardware procedures
53