Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual page 312

System board and components
CAUTION
An M.2 SSD in M.2 slot 2 is not recognized, if M.2 slot 1 is free.
▶
The M.2 slot 1 must be equipped first.
Each M.2 SSD needs one hexagon standoff for fastening. To support
different length of M.2 SSD, several nuts are on the system board
indicating the positions for fastening the M.2 SSD.
If no M.2 SSD has been installed before:
▶ Remove the screw (see orange circles in
If the hexagon standoff is unscrewed as well, remove the screw from
the hexagon standoff.
▶ Install the hexagon standoff on the right position depending on the length of
the M.2 SSD.
Figure 216: Installing the M.2 SSD
▶ With the label facing up, insert the M.2 SSD into the M.2 slot at a slight
angle.
312 Upgrade and Maintenance Manual
Figure 215).
RX1330 M4