Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual page 328

System board and components
▶ Remove all memory modules, see
page 238.
Before removing the memory modules, take a note on the installation
slot number for each memory module. Ensure that you install the
memory modules in the slot they were located before the
replacement.
▶ Remove all expansion cards, see
page 183.
Before removing the expansion cards, take a note on the installation
slot number for each card. Ensure that you install the card in the slot
it was located before the replacement.
▶ If applicable, remove the iRMC microSD card, see
microSD card" on page
▶ If applicable, remove all M.2 SSDs, see
page 314.
▶ If applicable, remove the Dual microSD 64GB Enterprise, see
the Dual microSD 64GB Enterprise" on page
Removing the defective system board
▶ Disconnect all cables from the system board.
328
"Removing memory modules" on
"Expansion cards and backup units" on
307.
Upgrade and Maintenance Manual
"Removing the iRMC
"Removing an M.2 SSD" on
319.
"Removing
RX1330 M4