Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual page 313

Figure 217: Fastening the M.2 SSD
▶ Fasten the M.2 SSD with the screw (see circle).
Concluding steps
▶ If applicable, install riser modules 2 and 3, see
page 61.
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
Software configuration
In order to install the ESXi to the M.2 SSD, the VMware ESXi installer CD is
required. To obtain the ESXi installer CD by purchasing the OEM Media Kit, or
downloading the ESXi Custom Image ISO file from the VMware website and
burn the image to the CD.
https://www.vmware.com/go/download-vsphere
Install the ESXi to the M.2 SSD by following the steps below:
▶ Disconnect all storage devices from the server beside the M.2 SSD.
▶ Power on the server. Once the server has been started, then enter the BIOS
setup menu and select the DVD drive as primary boot device.
▶ Insert the CD into the DVD drive and reboot the server. The server will boot
from the installer CD.
RX1330 M4
52.
56.
58.
Upgrade and Maintenance Manual
System board and components
"Installing a riser module" on
313