Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual page 237

▶ Align the notch on the bottom of the module with the crossbar in the slot.
▶ Press down on the memory module until the securing clips snap into the
cutouts at each end of the module.
Figure 149: Correct position of securing clips
To improve the contact of the memory module perform the following
steps:
▶ Eject the memory module again by pressing out the securing clips at each
end of the memory slot.
▶ Press down on the memory module until the securing clips snap into the
cutouts at each end of the module.
▶ Check if all securing clips are in the correct position, see
Concluding steps
▶
"Installing the air duct" on page
▶
"Reassembling" on page
RX1330 M4
64.
52.
Upgrade and Maintenance Manual
Main memory
Figure 149.
237