Converting A Standard Power Supply To A Redundant Power Supply - Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

▶ Push the lock spring inward to unlock the CMA stopper, see
CAUTION
▶
In case of not enough space at the under side, unlock the CMA
stopper of the server below and pull out the CMA to the rear
side.
▶ Remove the CMA stopper with the mounted crossbar, see
▶ Hold the CMA stopper, the crossbar and the CMA including cables in the
one hand.
▶ Remove the FJBU (see
▶ Mount the complete assembly (CMA stopper, the crossbar and the CMA)
again into the rail.
Preliminary steps
▶
"Locating the defective server" on page
Removing the defective FJBU
▶ Remove the FJBU, see
Installing the new FJBU
▶ Install the FJBU, see
Concluding steps
▶ No steps needed.
6.6 Converting a standard power supply to a
redundant power supply
Field Replaceable Unit
(FRU)
RX1330 M4
Figure 35) and install the new PSU carefully.
"Removing an FJBU" on page
"Installing an FJBU" on page
Upgrade and Maintenance Manual
Power supply unit (PSU)
43.
125.
124.
Hardware: 20 minutes
Figure 33.
Figure 34.
127