Set Object Group Parameters - Panasonic LP-GS Series Operation Manual

• You can specify different parameters to correct the marking position.
The following figure shows these parameters.
(5)
(1) X-movement
(2) Y-movement
(3) Z-movement
(4) Rotation (-)
(5) Rotation (+)
‒ " X-movement [mm]", "Y-movement [mm]":
‒ " Z-movement [mm]" (LP-GS except LP-GS051-L):
‒ "Rotation movement [°]":
Related topics
Set the laser head direction
General object/object group parameters
18.3

Set object group parameters

Specify parameters for the object group. The settings apply to all marking data in the
selected object group.
• To edit the parameters of an object group, select the object group in the object list.
The parameters are displayed in the category below the object list.
Specify any of the following parameters:
ME-NAVIS2-OP-1
(3)
+
Enter a value to move all marking data in the object group along the x-axis and y-
axis.
The orientation of the x- and y-axis is defined by the head direction setting.
Enter a value to position all marking data in the object group along the z-axis.
Specify an angle to rotate all marking data in the object group. The rotation center is
the center of the marking field. Enter a positive value for counterclockwise rotation
and a negative value for clockwise rotation.
(page 264)
(2)
-
(4)
(1)
(page 90)
18 Object group settings
193