Panasonic LP-GS Series Operation Manual page 187

The parameters are displayed in the category below the object list.
• Under "Human readable text", set the laser correction parameters.
Specify any of the following parameters:
• "Laser power correction [%]":
To correct the laser power, enter a value in the text box.
Marking is not possible if the laser power correction value is 0.
• "Scan speed correction [%]":
To correct the scan speed, enter a value in the text box.
• "Pulse cycle correction [%]" (LP-RF, LP-RV):
To correct the pulse cycle, enter a value in the text box.
If the corrected value exceeds the allowable limit, the marking is performed with the
maximum or minimum parameter value. The correction ratio is calculated based on the value
set as 100% in "Laser settings".
Related topics
Set laser parameters
Set parameters for the human readable text
ME-NAVIS2-OP-1
(page 230)
(page 184)
16 Human readable text parameters
187