Set Laser Correction Parameters For The Human Readable Text - Panasonic LP-GS Series Operation Manual

16 Human readable text parameters
(1) "Linefeed spacing [mm]": 1.5mm ("Character height [mm]": 1.0mm)
(2) "Linefeed spacing [mm]": 2.0mm ("Character height [mm]": 1.0mm)
Remarks
• Control characters are not shown in the human readable text.
• CODE39, NW-7: The start and stop characters are included in the human readable text.
For CODE39 the start/stop character is an asterisk (*).
• EAN/UPC/JAN, CODE39, ITF, NW-7: The check character or check digit is included in
the human readable text.
• If Application Identifier "01" is used, the check digit is included in the human readable text.
This applies to the following codes:
GS1 DataMatrix, GS1-128 (UCC/EAN-128), GS1 DataBar Limited, GS1 DataBar Limited
CC-A, GS1 DataBar Stacked, GS1 DataBar Stacked CC-A
Related topics
Automatically optimize GS1 DataBar parameters
About font files
About Application Identifiers
AI prefix codes

Set laser correction parameters for the human readable text

Specify the East Asian character set
Configure advanced system settings
16.2 Set laser correction parameters for the human readable text
Specify laser correction parameters for the human readable text of a bar code or 2D code
object.
• To edit the parameters of the bar code or 2D code object, select the object in the object
list or in the marking image editor.
186
(1)
(page 68)
(page 188)
(page 189)
(page 224)
(page 261)
(2)
(page 153)
(page 186)
ME-NAVIS2-OP-1