Connection With Laser Marker Navi Smart - Panasonic LP-GS Series Operation Manual

Cause:
Power is not supplied to the common terminal of the TERMINAL
connector.
Remedy:
Connect the internal or external power supply to IN COM. 1 (X2) and
OUT COM.1 (Y2) on the TERMINAL connector.
Laser pumping does not start in remote mode
Cause:
Signals from the external device cannot be transmitted.
Remedy:
Refer to
Cause:
The setting for "Laser pumping control" does not match the actual control
method.
Remedy:
• Check if the setting for "Laser pumping control" ("I/O" or
"Communication commands") in the "Operation/information" window
of the "System settings" screen is correct.
• A change of this setting will take effect only after restarting the laser
marking system.
27.4

Connection with Laser Marker NAVI smart

If a connection to the laser marking system is not possible, check the condition of your PC
and the communication settings.
Laser marking system not available in the "Connection" dialog
Cause:
The laser marking system has not been started.
Remedy:
Refer to
Cause:
PC and laser marking system are not connected.
Remedy:
Connect PC and laser marking system with a USB cable or a LAN cable.
ME-NAVIS2-OP-1
External control (page 309).
Start-up (page 295).
27 Troubleshooting
297