Marking Trigger Input; Equidistant Marking (Flying Object Marking) - Panasonic LP-400 Series External Control Manual

2-4-2 Marking trigger input

READY OUT
TRIG. IN
MARKING OUT
WARNING OUT
(Active low)
Item Time
T1 10ms or more
T2 2 to 510ms
Reference
• The marking is started when TRIG. IN is turned to ON while either the delay time or delay distance is 0.

2-4-3 Equidistant marking (Flying object marking)

ON
READY OUT
OFF
ON
TRIG. IN
OFF
ON
MARKING OUT
OFF
ON
MARK END OUT
OFF
Item Time
T1 ―
T2 ―
T3 2 to 510ms
Reference
• Equidistant marking is performed while TRIG. IN is ON.
• The laser marker stops after marking is completed if TRIG. IN is turned to OFF during marking.
• Equidistant marking is performed after travels the distance that is set in the "trigger ready".
ON
OFF
ON
T1 T1
OFF
ON
OFF
ON
OFF
Remarks
Keep the ON status for 10ms or more.
It outputs a warning to notify that an invalid trigger was input when a marking trigger was
input during the marking operation. This is One-shot output. You can turn this warning off
by the settings.
T2
T1
T3
Remarks
The time when the work travels the distance set in the "trigger delay".
The time when the work travels the distance set in the "interval" of the moving object.
One-shot output. Set the output time on the environment setting screen. There is a small
margin of error for the setting value.
T2
T2 T2
T3 T3 T3
ME-LP400V-EX-6
47