On-The-Fly Marking; About On-The-Fly-Marking - Panasonic LP-GS Series Operation Manual

23 On-the-fly marking

23 On-the-fly marking
23.1

About on-the-fly-marking

Specify on-the-fly marking settings if you want to mark a workpiece in motion, e.g. a
workpiece that move on an assembly line.
On-the-fly marking is available for LP-RC, LP-RF and LP-RV.
The parameters for on-the-fly marking are located on the "Marking settings" screen in the
"On-the-fly marking" tab.
The following functions are not available for on-the-fly marking:
• "File settings" > "Image checking before marking", "Image checking after marking"
• "Object group" > "Overwriting interval [s]"
• 2D code: "Object settings" > "Module marking order" > "Skip one", "Skip two"
To enable on-the-fly marking and display the settings, select "ON" for "On-the-fly marking".
Select "OFF" to disable the function.
Under "On-the-fly settings for all files", specify the basic parameters. The settings apply to all
files in the laser marking system.
Under "On-the-fly settings for one file", specify the detailed parameters. The settings apply
only to the current file.
Vibrations coming from surrounding equipment or line speed fluctuations may affect the marking
quality of bar codes or 2D codes during on-the-fly marking. When marking a bar code or 2D code on
a moving workpiece, check that the marking and reading results of the marked code are of sufficient
high quality.
Related topics
On-the-fly marking settings for all files
On-the-fly-marking settings for one file
Trigger mode parameters
Line speed control setting "2 sensors input"
Specify on-the-fly marking settings
240
(page 241)
(page 244)
(page 247)
(page 249)
(page 249)
ME-NAVIS2-OP-1