Point Radiation Object; Create A Point Radiation Object - Panasonic LP-GS Series Operation Manual

13

Point radiation object

13.1

Create a point radiation object

Use a point radiation object if you want to mark the workpiece at a specified coordinate.
1. Select the "Point radiation" tool in the ribbon.
2. In the dialog, configure any of the following settings:
•
•
•
•
3. Select "OK".
The point radiation object represented by a + symbol is displayed in the marking image
editor and is highlighted in the object list.
4. To edit the parameters of the point radiation object, select the object in the object list or
in the marking image editor.
The parameters are displayed in the category below the object list.
Related topics
General object/object group parameters
Edit, add or delete a point in an existing point radiation object
Position or rotate a point radiation object
Set laser correction parameters for a marking object
ME-NAVIS2-OP-1
During radiation, the laser power is concentrated onto one point. Use caution when setting
long radiation periods. It may cause fire and damage to the workpiece.
"X-position [mm]", "Y-position [mm]":
Enter values to specify the position of the point.
"Radiation time":
Set the duration of the laser radiation.
"Time unit":
Specify your preferred time unit (millisecond, second, minute or hour).
"Laser power correction [%]":
To correct the laser power of the point, enter a value in the text box.
The laser power is set by multiplying the laser power correction ratio set for the point
and the laser power value set in "Laser settings".
Marking is not possible if the laser power correction value is 0.
(page 90)
(page 142)
(page 143)
(page 238)
13 Point radiation object
141