Ensuring That The Cleaning Device Is Depressurised - Fronius Robacta Reamer Alu Edition Manual

If work has to be performed on the cleaning device while it is being supplied with voltage
and/or compressed air:
► keep your body, especially your hands, face, hair, any objects and all clothing away
► wear ear protection
► wear protective goggles with side protection
Ensuring that the Attempt to briefly activate the cleaning device without any compressed air supply to check
cleaning device is whether the cleaning device is depressurised. Proceed as follows:
depressurised
1
2
On the Robacta Reamer Alu Edition, Robacta Reamer Alu 3000upm:
3
-
-
On the Robacta Reamer Twin:
3
-
-
36
from the cleaning cutter / cleaning brush, lifting device, gas nozzle clamping device,
wire cutter and parting-agent injection nozzles
Take protective measures:
- The cleaning cutter / cleaning brush, lifting device, gas nozzle clamping device,
wire cutter and parting-agent injection nozzles could start up. Therefore keep your
body, especially your hands, face and hair, any objects and all clothing away from
the parts referred to above
- wear ear protection
- wear protective goggles with side protection
Ensure that the cleaning device has been disconnected from the compressed air sup-
ply
Briefly turn the "Cleaning" screw on the cleaning device 90° to the right, then turn it
straight back to its original position
If the cleaning device does not respond to the turning of the screw, the cleaning device
is depressurised
If the cleaning device responds to the turning of the screw, the cleaning device is still
connected to a compressed air supply.
If this is the case, you must disconnect the cleaning device from the compressed air
supply and check again that the cleaning device is depressurised before starting work
Briefly press the valve lever on the cleaning device wire cutter to the side by more than
15° using a tool
If the cleaning device wire cutter does not respond to the movement of the valve lever,
the cleaning device (including the wire cutter) is depressurised
If the wire cutter responds to the movement of the valve lever, the cleaning device (and
therefore also the wire cutter) is still connected to a compressed air supply.
If this is the case, you must disconnect the cleaning device from the compressed air
supply and check again that the cleaning device is depressurised before starting work