Procedure - Agilent Technologies PSA Series Manual

Figure 4-16 Equipment Setup

Procedure

1. Connect the equipment as shown in
2. Set the synthesized sweeper controls as follows:
, 40,
Frequency MHz
, –10,
POWER LEVEL
, –4.3,
POWER LEVEL
75 Ω Input only. Connect the minimum loss adapter between the low pass
NOTE
filter and 75 Ω Input.
3. Press ,
System Power On/Preset
preset routine to finish.
Set the analyzer by pressing the following keys:
,
AMPLITUDE More
,
FREQUENCY Center Freq
, 1,
SPAN MHz
, –10,
AMPLITUDE
, 44,
AMPLITUDE dBmV
(Man), 10,
Attenuation
, , 30,
BW/Avg Res BW
4. Adjust the synthesized sweeper power level to place the peak of the signal at the
reference level.
5. Set the analyzer by pressing the following keys:
, 50,
SPAN kHz
, , 1,
BW/Avg Res BW
, 100,
Video BW Hz
Chapter 4
Figure 4-15
(50 Ω Input only)
dBm
(75 Ω Input only)
dBm
, (Factory),
Preset Type
, ,
Y Axis Units dBm
, 40,
MHz
(50 Ω Input only)
dBm
(75 Ω Input only)
dB
kHz
kHz
Second Harmonic Spurious Responses
or Figure 4-16.
on the analyzer. Wait for the
Preset
ESA Functional Tests
185