120 Khz Procedure - Agilent Technologies PSA Series Manual

2. Press on the analyzer and wait for the preset routine to finish. Set the analyzer
Preset
up by pressing the following keys:
,
Input/Output Amptd Ref Out (f=50 MHz)
,
FREQUENCY Center Freq
, 500,
Span kHz
,
AMPLITUDE Attenuation
, ,
BW/Avg Res BW
, 25,
AMPLITUDE —dBm
, 20,
AMPLITUDE —dBm
Peak Search
,
MEASURE Meas at Marker
3. Wait for the Measure at Marker routine to finish and then record the peak, quasi-peak,
and average values measured by the analyzer. When the measurement is complete, a
box will appear in the upper left hand corner of the screen with the most recent
measurement information. Record these in your worksheet (in
9 kHz Procedure.

120 kHz Procedure

1. Connect the equipment as shown in Figure 4-3. on page 159.
For the HP E7401A, it is not necessary to connect the AMPTD REF OUT to
NOTE
the analyzer's 50Ω input. It switches internally.
2. Press on the analyzer and wait for the preset routine to finish. Set the analyzer
Preset
up by pressing the following keys:
,
Input/Output Amptd Ref Out (f=50 MHz)
,
FREQUENCY Center Freq
, 2,
Span MHz
,
AMPLITUDE Attenuation
, ,
BW/Avg Res BW
, 25,
AMPLITUDE —dBm
, 20,
AMPLITUDE —dBm
Peak Search
,
MEASURE Meas at Marker
3. Wait for the Measure at Marker routine to finish and then record the peak, quasi-peak,
and average values measured by the analyzer. When the measurement is complete, a
box will appear in the upper left hand corner of the screen with the most recent
measurement information. Record these in your worksheet (in
120 kHz Procedure.
Chapter 4
(On)
, 50,
MHz
, 5, , ,
dB More Y Axis Units
, , 10,
9 kHz Video BW Hz
(E7401A only)
(E7402A, E7403A, E7404A, and E7405A only)
(On)
, 50,
MHz
, 5, , ,
dB More Y Axis Units
, , 300,
120 kHz Video BW
(E7401A only)
(E7402A, E7403A, E7404A, and E7405A only)
,
dBm
Table 4-2 on page
,
dBm
Hz
Table 4-2 on page
ESA Functional Tests
EMI Detector Test
162) in
162) in
161