Preset Adjustment: Simple Method; Preset Adjustment: Advanced Method - Lutron Electronics QSGRJ-3P Installation And Operation Manual

Adjusting Shade Settings

Preset Adjustment: Simple Method

1. Use the raise and lower buttons on the
shade button group to set all electronic
drive units (EDUs) of the shades to the
desired preset levels.
2. Press and hold the middle button on the
shade button group for 5 seconds to
save the EDU preset positions. The LED
next to the button will flash and then light
continuously, indicating the preset has
been stored.
Note: Once EDU presets have been
assigned to buttons on a shade
button group, those presets are
accessible for an EDU only using
the shade button group it is
assigned to, and a shade button
group can access preset levels
only for those EDUs assigned to it.
®
(for Wired and Wireless Sivoia

Preset Adjustment: Advanced Method

• The advanced method for adjusting
presets is needed only if you wish to
have the shades assigned to the shade
button group set at different positions in
the preset. If, however, you wish all the
shades in the group to be lined up with
one another in the preset, you should
use the Simple Method at left.
• Entering "Assignment" mode will cause
the shades to move between their open
and close limits. Verify that the open and
close limits have been set correctly.
1. On the shade button group whose
preset you wish to adjust, press and
hold simultaneously the top and bottom
buttons. The LEDs next to the buttons
will flash. EDUs for the assigned shades
will move to their closed limits, and EDUs
for unassigned shades will move to their
open limits.
2. Press and release the middle button on
that shade button group. The adjacent
LED will blink rapidly. EDUs for assigned
shades will automatically move to their
current preset settings.
QS Shades/Drapes)
®
3. Use the raise and lower buttons to move
all EDUs for assigned shades together to
the desired preset setting.
4. To move an EDU individually to its
desired preset setting, select the EDU
using the top button on the shade button
group. Each time you press and release
the top button, a different EDU that is
assigned to that shade button group
will open and close in an 8 in (200 mm)
range. Press repeatedly until the EDU
for the shade you wish to adjust moves.
Adjust that EDU to the desired height
using the raise and lower buttons.
Repeat this step for all assigned EDUs.
5. Once you are satisfied that all the
assigned EDUs are set to the positions
you want to assign as the preset, press
and hold the middle button on the shade
button group for 5 seconds. The preset
will be saved.
6. Press and hold simultaneously the top
and bottom buttons on the shade button
group for 5 seconds to exit to normal
mode. The LEDs next to the buttons will
stop flashing.
GRAFIK Eye QS Control Unit Installation and Operation Guide 46
®
(continued)