Air Duct Replacement; Hot-Swap Fan Module Replacement - Inspur NF3180A6 User Manual

4.4.3

Air Duct Replacement

For proper cooling, do not operate the server without the top cover, air

ducts, expansion slot covers, or blanks installed.
If the server supports hot-swap components, minimize the amount of time

the top cover is open.
To remove the air duct:
1. Remove the top cover.
2. Remove the super-capacitor on the air duct.
3. Remove the air duct in the direction of arrow.
Figure 4-5 Removing the Air Duct
To install the air duct:
1. Lower down the air duct vertically into the chassis.
2. Install the super-capacitor.
3. Install the top cover.
4.4.4

Hot-Swap Fan Module Replacement

To remove the fan module:
1. Remove the top cover.
2. Remove the fan module:
a. Lift up the fan module out of the fan bay.
28