Air Duct Replacement; Hot-Swap Fan Module Replacement - Inspur NF5280M6 User Manual

3. Connect the cable of the super-capacitor.
4. Install the access panel.

4.4.3 Air Duct Replacement

For proper cooling, do not operate the server without the access panel, air ducts,
expansion slot blanks, or other blanks installed. If the server supports hot-swap
components, minimize the amount of time the access panel is open.
To remove the air duct:
1. Remove the access panel (Refer to the
2. Remove the super-capacitor on the air duct (Refer to
Replacement).
3. Remove the air duct with both hands to remove it.
Figure 4-5 Removing the Air Duct
To install the air duct:
1. Lower down the air duct into the chassis until it snaps into place.
2. Install the super-capacitor.
3. Install the access panel.

4.4.4 Hot-Swap Fan Module Replacement

To remove the fan module:
Access Panel Replacement).
Super-Capacitor
29