Table of Contents
Advertisement
Figure 4-3 Removing the Access Panel
To install the access panel:
1.
Align the standoffs on the access panel with the J-slots on the server and lower
down the access panel with the hood latch open.
2.
Press down the hood latch until it locks into place. Make sure the access panel
snaps into place.
3.
Tighten the screw on the hood latch clockwise to the locked position with a Phillips
screwdriver.
4.4.2 Air Duct Replacement
To reduce the risk of personal injury from hot surfaces, allow the machine to cool
before touching.
For proper cooling, do not operate the server without the access panel, air ducts,
expansion slot blanks, or other blanks installed. If the server supports hot-swap
components, minimize the amount of time the access panel is open.
To remove the air duct:
1.
Remove the access panel (Refer to the Access Panel Replacement).
27
Hide quick links:
Advertisement
Table of Contents
