Precautions - Inspur NF3180A6 User Manual

an explosion. Never attempt to disassemble, crush or puncture a battery or
short circuit the battery. Do not throw it into fire or water, or expose it to an
environment over 60°C (140°F). Never attempt to open or repair a battery.
Dispose of used batteries properly. Do not mix used batteries, circuit boards or
other components that may contain batteries with other wastes. For battery
recycling, contact the local recycling center.
For stand-alone cabinets, install front and side leveling feet before installing

devices into the cabinets. For cabinets connected with other cabinets, install
front leveling feet first. Be sure to install the leveling feet before installing
devices into cabinets to prevent the cabinets from tipping over, possibly
resulting in personal injury. After installing devices and other components in
the cabinet, slide only one component out of the cabinet at a time. Pulling out
multiple components at a time may cause the cabinet to tip over and result in
personal injury.
Do not move the cabinet alone. At least two people are required to move the

cabinet.
It is prohibited to directly short-circuit the copper busbar. Do not touch the

copper busbar when the cabinet is powered on.
This is a Class A product, and may cause radio interference. In such case, you

may need to take necessary measures to mitigate the interference.
1.2

Precautions

Before using the product, read through the following precautions to avoid the
issues that may cause component damage or data loss.
Unplug the product's power plug from the power socket and contact Inspur

Customer Service under any of the following circumstances:
The power cables or power plugs are damaged.
-
The product gets wet with water.
-
The product falls off or is damaged.
-
Other objects fall into the product.
-
The product does not work properly when the operating instructions are
-
followed.
If the system is exposed to moisture, follow the steps below.

a. Power off the system and devices. Disconnect their power cables, wait 10
to 20 seconds, and then remove the top cover.
b. Move the devices to a ventilated area to dry the system off for at least 24
hours. Make sure that the system is fully dried.
2