Table of Contents
Advertisement
5
Battery Replacement
The server CMOS contains an internal lithium cell. A risk of fire and burns exists if
the battery is not properly handled. To reduce the risk of personal injury:
DO NOT recharge the battery.
Do not expose the battery to an environment where the temperature is
higher than 60°C (140°F).
DO NOT disassemble, crush, puncture, short-circuit external contacts, or
dispose of the battery in fire or water.
Replace only with the spare designated for this product.
To avoid damage to the components due to ESD, use conductive foam pads
or antistatic wristbands.
To replace the battery:
1.
Power off the server and disconnect all the power cables to remove power
completely.
2.
Gently slide and remove the server out of the rack.
3.
Remove the top cover.
4.
Remove any full-length expansion card if the card is in the way.
5.
Locate the CMOS battery on the motherboard.
6.
Gently press the clip on the battery socket until the battery pops up from the
socket.
7.
Remove the battery from the battery socket.
DO NOT pry or press the battery with excessive force.
Failing to remove the battery properly might damage the socket on the
motherboard. Any damage to the socket might require replacing the entire
base with the motherboard.
8.
Dispose of the battery as required by local ordinances or regulations.
44
Advertisement
Table of Contents
