Inspur NF3180A6 User Manual page 12

c. Close the top cover, reconnect the system's power cable, and power on
the system.
d. If it cannot operate normally, contact Inspur for technical support.
The cable routing should ensure that the system cables and power cables will

not be stepped on or knocked off. Do not place any objects on the cables.
Before removing the top cover or accessing any inner component, wait until

the device is cooled down. After the system is powered off, wait 5 seconds
before removing components from the motherboard or disconnecting
peripherals to avoid damage to the motherboard.
If a modem, telecom or LAN option is installed:

Do not connect or use the modem in the event of lightning to avoid
-
lightning strikes.
Never connect or use the modem in a damp environment.
-
Never insert the modem or telephone cables into the socket of network
-
interface controller (NIC).
Before unpacking the product, accessing or installing inner components,
-
or touching an uninsulated modem cable or jack, be sure to disconnect the
modem cable.
To prevent electrostatic discharge from damaging electronic components

inside the device:
Ground yourself before installing, removing, or accessing any electronic
-
components inside the device. You may remove the static electricity from
your body by touching a grounded metal object (such as the unpainted
metal surface of the chassis).
Do not take out ESD-sensitive components from their anti-static packages
-
if they are not intended for use.
Regularly touch grounded conductors or unpainted metal surface of the
-
chassis during operation to discharge static electricity from your body that
could damage inner components.
When installing or removing any components inside the system with the

permission of Inspur:
a. Power off the system and disconnect its power cables and all the cables
connected to the system. Disconnect the cable by holding the cable
connector (instead of the cable) and pulling it out.
b. Only after the products completely cool down can you disassemble the top
cover or access the internal components.
3