Firmware Update And Configuration; Cable Routing - Inspur NF3180A6 User Manual

4. Remove the screws of all four corners of the E1.S drive bay.
5. Remove the E1.S upwards.
Figure 4-23 Removing the E1.S
To install the E1.S:
1. Tighten the fours screws securing the E1.S to the drive bay.
2. Install the front panel of the drive bay.
3. Install the E1.S module into the server and close the lever.
4.5

Firmware Update and Configuration

For firmware update and configuration, please refer to:
BIOS Update Manual

BIOS User Manual

BMC Update Manual

BMC Configuration Manual

4.6

Cable Routing

Blue indicates the data cable routing between the backplane and SAS/RAID
controller card;
Red indicates the cable routing between the backplane power connector and the
42